Momentum Worx S410SX Cat Turbo | 80MM / 1.32 A/R Wastegated
We took our popular 80MM bolt on upgrade for Caterpillar 3406E and Caterpillar C15 Engines. (6NZ, 5EK, 1LW, etc), and added wastegate :)
This turbo serves a few potential customers:
1) The customer running slightly too much power for a traditional non gated 1.32, this will allow you to retain the quick low end spool up of a 1.32, without overspeeding the turbo up top and causing a turbo failure.
2) The customer who doesnt have enough gusto to push a 1.45 housing
3) The customer that wants to add a manual boost controller and dial in peak boost and boost ramp up to their specific need (Careful here boys, good way to blow you're shit up if you're not careful)
Good for roughly 650HP depending on supporting mods, recomended for trucks running a very aggressive tune on factory injectors, or a larger injector set. Gate starts to open around 29PSI, slowing boost ramp up, then the gate is fully open at 38PSI. The turbo *MAY* build more then 38PSI as internal gates fully open can still allow enough exhaust gas to continue to spool the turbo. Elevation and other factors will have an impact here.
Billet compressor wheel
360 degree thrust bearing
Comp. Wheel: 80MM/110MM
Turbine Wheel: 96MM/88MM
A/R: 1.32 Waste Gated
This turbo is assembled in balanced in the U.S.A!
NOW INCLUDED: Momentum Worx Unlimited 1 Year Warranty
Brand new turbo, no core required.